Brother PJ673-K Manual page 67

Problem
I want to print using either a wireless LAN
connection or a USB connection.
The wireless connection takes time.
Solution
Set up the printer for both a wireless LAN connection and a
USB connection. If the printer was set up for only one
communication method, it cannot be switched.
 If the wireless LAN driver was not installed during the USB
installation:
a. With the default settings
See Adding a Printer on page 19.
b. With the default settings changed
See Setting Up the Printer (With the Default Settings
Changed) on page 22.
If printing is not possible after performing step a. and b.
Check the network connection.
See Setting Up the Computer Running Windows
on page 17.
In addition, see Switching Between Wireless LAN Mode
and USB Mode on page 30.
 If the driver of the desired interface is not be selected:
The driver of the desired interface must be selected.
When the printer is installed, Brother PJ-673 and Brother
PJ-673 USB drivers are installed.
If printing is still not possible, see Switching Between
Wireless LAN Mode and USB Mode on page 30.
 If the printer interface cannot be switched:
See Switching Between Wireless LAN Mode and USB
Mode on page 30.
From initialization to completing the connection takes time, so
it may take 1 minute or more to establish the wireless LAN
connection. Since this differs depending on the device and
environment, check with the device manufacturer. For details
on the printer's wireless LAN preparation time, see Switching
Between Wireless LAN Mode and USB Mode on page 30.
Troubleshooting
®
63
6