Brother PJ673-K Manual page 16

Chapter 1
f
When the WIRELESS LAN indicator
stops blinking and remains lit, the printer
is connected.
Print from the printing software created
with the SDK.
NOTE
It may take more than 1 minute to
establish a wireless LAN connection.
Since it differs depending on the device
and environment, check with the device
manufacturer.
 If printing is not possible
In the following cases, the wireless LAN
connection between the printer and iOS
device will be cut, preventing printing.
1 The iOS device has entered sleep
mode.
2 The printer has been turned off.
3 The printer has been switched to USB
mode.
For the cases mentioned above, perform
the operations below to re-establish the
connection.
1 Select the SSID for the ad-hoc mode
for step e on page 11.
2 Select the connection for step a on
page 11.
3 Hold down the
least 3 seconds to enter wireless LAN
mode, and then select the SSID for the
ad-hoc mode for step c on page 11.
12
(Power) button for at
Setting Up the Printer
(With the Default Settings Changed)
NOTE
• A computer running Windows
cable are required to change the printer's
default settings, even if the printer will be
used by an iOS device via a wireless LAN
connection. In the process, the printer
driver for a USB connection will be
installed on the computer running
®
Windows .
• In order to use the printer via a wireless
LAN connection, settings must be
specified on both the printer and the iOS
device. The printer settings will be
specified with the printer driver; however,
the settings on the iOS device must be
specified manually. Specify the settings
according to the procedures in this
manual.
• With administrator rights, log onto the
computer running Windows
• If, while specifying the settings, a dialog
box appears, requesting administrator
rights or requesting confirmation to
perform the operation with administrator
rights, follow the instructions.
• If, while specifying the settings, a dialog
box appears, requesting confirmation to
continue the installation, continue it.
• The descriptions in this manual apply to
wireless network connections that can be
set up using a standard procedures for
your operating system. For any other
cases, refer to the instruction manual
included with your wireless adapter.
a
If you have the included CD-ROM, insert
it into your computer's CD-ROM drive,
and then click [Standard Installation] in
the installer screen that appeared. If the
Web version was download, run the
downloaded file.
Click [Next].
1
®
and a USB
®
.