Brother PJ673-K Manual page 54

Chapter 3
Defining Internal Font Settings
1 Extended Characters
Available settings: [Italic], [Graphics]
Default setting: [Graphics]
This parameter determines which characters
are used when printing ASCII characters 128
to 255. When [Italic] is selected, italic versions
of ASCII characters 32 to 127 are used. When
[Graphics] is selected, the characters shown
in the table on page 68 are used.
2 Character Set Map
Available settings: [USA], [France],
[Germany], [United Kingdom], [Denmark I],
[Sweden], [Italy], [Spain I], [Japan], [Norway],
[Denmark II], [Spain II], [Latin America],
[Korea], [Legal]
Default setting: [USA]
This parameter determines which character set
is used, allowing you to print special characters
appropriate for the language selected. See the
table on page 70 for details.
3 Default Font
Available settings: [Serif], [Sans Serif]
Default setting: [Serif]
This parameter determines which built-in font
is used. A serif font (similar to Courier) and a
Sans Serif font (similar to Letter Gothic) are
built-in.
4 Reduce Character Size
Available settings: [Disable], [Enable]
Default setting: [Disable]
This parameter determines whether text is
printed at a reduced size. The actual size of the
text depends on the setting selected for
[Default Pitch], as shown below.
50
1
2
3
4
5
Default Pitch
10 characters/inch
12 characters/inch
Proportional
15 characters/inch
5 Character Attribute
Available settings: [Bold], [Double Width],
[Underline]
This parameter determines the attributes used
for printed text.
3
Reduced Size
16.67 characters/inch
20 characters/inch
Half the character
width
Does not change