Security Unlock(X'f2') - Fujitsu MHW2040AC Product Manual

(30) SECURITY UNLOCK(X'F2')

This command cancels LOCKED MODE.
The host transfers the 512-byte data shown in Table 5.26 to the device. Operation
of the device varies as follows depending on whether the host specifies the master
password.
When the master password is selected
•
When the security level is LOCKED MODE is high, the password is compared
with the master password already set. If the passwords are the same, LOCKED
MODE is canceled. Otherwise, the Aborted Command error is returned. If the
security level in LOCKED MODE is set to the highest level, the Aborted
Command error is always returned.
When the user password is selected
•
The password is compared with the user password already set. If the passwords
are the same, LOCKED MODE is canceled. Otherwise, the Aborted Command
error is returned.
If the password comparison fails, the device decrements the UNLOCK counter.
The UNLOCK counter initially has a value of five. When the value of the
UNLOCK counter reaches zero, this command or the SECURITY ERASE UNIT
command causes the Aborted Command error until the device is turned off and
then on, or until a hardware reset is executed. Issuing this command with
LOCKED MODE canceled (in UNLOCK MODE) has no affect on the UNLOCK
counter.
Issuing this command in FROZEN MODE returns the Aborted Command error.
1F7 (CM)
h
1F6 (DH)
h
1F5 (CH)
h
1F4 (CL)
h
1F3 (SN)
h
1F2 (SC)
h
1F1 (FR)
h
C141-E258
At command issuance (I-O register contents)
1 1 1
x x x
xx
xx
xx
xx
xx
1 0 0 1
DV xx
5.3 Host Commands
0
5-95