Measuring At One Listening Position (Single Measure) - Yamaha RX-A1010 Owner's Manual

1 2 3 4 5 6 7 8 9
Automatic speaker setup
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7
V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI USB USB NET NET
DOCK DOCK TUNER TUNER [ A ] [ A ] [ B ] [ B ]
SCENE
1 2 3 4
PROGRAM MUTE VOLUME
TOP MENU POP-UP/MENU
ON SCREEN OPTION
Cursor keys
ENTER
ENTER ENTER
RETURN RETURN
RETURN DISPLAY
MODE
LIVE
CLASSICAL ENTERTAIN
CLUB
PRESET
MOVIE STEREO STRAIGHT
TV
PURE
INPUT
DIRECT
TV VOL TV CH
MUTE
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below to
make the measurement.
• YPAO measurement is not performed correctly when any obstacles are in the
room.
• During the measuring process (about 3 minutes), keep stuff in the corners or
remove it from the room.
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement, press RETURN.
The following screen appears on the TV when the
measurement finishes.
• If any error message (such as E-1) or warning message (such as W-1)
appears, see "Error messages" (p.50) or "Warning messages" (p.51).
• To check the measurement results, select "Result". For details, see
"Checking the measurement results" (p.49).
2
Use the cursor keys to select "Save/Cancel" and
press ENTER.
3
To save the measurement results, use the cursor
keys to select "SAVE" and press ENTER.
The corrected speaker settings are applied.
• To finish the measurement without saving the result, select "CANCEL".
4
Disconnect the YPAO microphone from this unit.
Now optimization of the speaker settings is complete.
Caution
• Since the YPAO microphone is sensitive to heat, do not place the microphone
in any place where it will be subjected to direct sunlight or high temperatures
(top of an AV equipment, etc).
47
En