Network - Yamaha RX-A1010 Owner's Manual

■
Audio Output
Selects a device to output audio.
• The "Amp" and "HDMI OUT1" settings are available only when "HDMI Control" is set to "Off".
❑ Amp
Enables/disables the audio output from the speakers connected to this unit.
Settings
Off Disables the audio output from the speakers.
On (default) Enables the audio output from the speakers.
❑ HDMI OUT1, HDMI OUT2
Enables/disables the audio output from a TV connected to the HDMI OUT 1 jack or
HDMI OUT 2 jack.
Settings
Off (default) Disables the audio output from the TV.
On Enables the audio output from the TV.
■
Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when this
unit is in standby mode.
Settings
Off (default) Does not output videos/audio to the TV.
Outputs videos/audio to the TV.
On
(This unit consumes approximately 3 W of power.)
• This setting is available only when "HDMI Control" is set to "Off".

Network

Configures the network settings.
■
IP Address
Configures the network parameters (IP address, etc).
❑ DHCP
Select whether to use a DHCP server.
Settings
Does not use a DHCP server. Configure the network parameters
Off
manually.
Uses a DHCP server to automatically obtain the network parameters (IP
On (default)
address, etc.) of this unit.
❑ Manual Setup
Configures the network parameters of this unit manually when "DHCP" is set to "Off".
Submenu
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.
112
En