Counter Balance Spring Adjustment; Installation - Viking RVDW324 Installation Manual

Counter Balance Spring Adjustment

1
2
Disconnect cable from hook.
Increase
tension
3
Decrease
tension
Set counter balance spring connector in appropriate
location.
Note: For custom panel installation,
the door may require adjustment
to the preload of the counterbalance
springs. Follow these steps to
adjust the tension.
12
(if necessary)
2
1
Remove spring from dishwasher.
4
2
Reconnect cable to hook.

Installation

1
2
2
4
x4
3
Carefully lay dishwasher on its back and attach the kick To adjust the depth of the kick plate, loosen screws on
plate brackets. Screws for the brackets will already be the bracket and position in the required depth. Tighten
in the base. Note: Be careful not to pinch hoses or
power cord beneath dishwasher.
3
Using tie strap attached to dishwasher, band water line,
drain line, and power cord together.
5
Position unit in front of cutout.
Slide unit into opening; be sure to feed water, electrical
13
2
2
screws and repeat for other side.
4
1
1
2
x2
Attach brackets with two screws (1 per bracket).
6
and discharge lines into adjacent cabinet.