Viking RVDW324 Installation Manual page 3

IMPORTANT–
Please Read and Follow!
W A R N I N G
Disconnect the electrical power supply and
ELECTRICAL SHOCK HAZARD
place a tag at the disconnect switch
• Electrically ground dishwasher.
indicating that you are working on the
• Connect ground wire to green ground
circuit.
connector in terminal box.
• DO NOT use an extension cord.
• Failure to follow these instructions, can
result in death, fire or electrical shock.
Be sure electrical power is turned off at
circuit breaker or fuse box before servicing
W A R N I N G or installing unit. DO NOT use an
extension cord for this appliance.
TIP OVER HAZARD
• DO NOT use dishwasher until
completely installed.
• DO NOT push down on open door.
Improper connection of the equipment –
• Doing so can result in serious injury
grounding conductor can result in a risk of
or cuts.
electric shock. Check with a qualified
electrician or serviceman if you are in
W A R N I N G
doubt as to whether the appliance is
properly grounded. DO NOT modify the
EXCESSIVE WEIGHT HAZARD
plug provided with the appliance; if it will
Use two or more people to move and
not fit the outlet, have a proper outlet
install dishwasher. Failure to do so can
installed by a qualified electrician.
result in back or other injury.
W A R N I N G
Plumbing connections must comply with
applicable sanitary, safety, and plumbing
codes.
C A U T I O N
The dishwasher has a factory installed
backflow preventer. DO NOT add an
additional check valve.
4
W A R N I N G
W A R N I N G
W A R N I N G
IMPORTANT –
Please Read and Follow
A GFI shall be used if required by NFPA-
70 (National Electric Code),
federal/state/local laws, or local
ordinances.
• The required use of a GFI is normally
related to the location of a receptacle with
respect to any significant sources of water
or moisture.
• Viking Range will NOT warranty any
problems resulting from GFI outlets which
are not installed properly or do not meet
the requirements below.
If the use of a GFI is required, it should be:
• Of the receptacle type (breaker type or
portable type NOT recommended)
• Used with permanent wiring only
(temporary or portable wiring NOT
recommended)
• On a dedicated circuit (no other
receptacles, switches or loads in the
circuit)
• Connected to a standard breaker of
appropriate size (GFI breaker of the same
size NOT recommended)
• Rated for Class A (5 mA +/- 1 mA trip
current) as per UL 943 standard
• In good condition and free from any
loose-fitting gaskets (if applicable in
outdoor situations)
• Protected from moisture (water, steam,
high humidity) as much as reasonably
possible
5