Final Installation
(cont.)
14
Install kick plate.
16
Performance Checklist
Testing for Leaks
Unit Reset
A qualified installer should carry out the following
• If the unit should need to be reset for any
checks:
reason, push and hold the "START" button for
4 seconds.
□
Remove packaging and parts.
□
Turn on the water supply and check for leaks.
□
Turn the power on at breaker/fuse box and
test the dishwasher operation by running a
rinse and hold cycle. (This should take about
12 minutes.)
□
Turn off the electrical power and check for
leaks under the dishwasher.
□
Make sure that no kinks have developed in
the drain lines.
Final Preparation
• Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
17