Table of Contents
Warnings & Important Information _____________________________________________________3
Specifications _______________________________________________________________________7
Site Preparation__________________________________________________________________8
Water Supply ____________________________________________________________________8
Drain ___________________________________________________________________________8
Installation _____________________________________________________________________13
Leveling _______________________________________________________________________14
2
IMPORTANT
-
Please Read and Follow
• Before beginning-please read these
• Please ensure that this product is properly
instructions completely and carefully.
grounded.
• DO NOT remove permanently affixed
• The installer should leave these
labels, warnings, or rating plates from the
instructions with the consumer who should
dishwasher. This may void warranty or
retain for local inspector's use and for
create an unsafe product.
future reference.
• Please observe all national and local
• The dishwasher has a factory installed
codes.
backflow preventer. DO NOT add an
additional check valve.
W A R N I N G
• Failure to provide a 20" above floor level
Make sure that incoming voltage is the
(50.8 cm) high loop may result in improper
operation of the dishwasher.
same as unit rating. An electric rating
plate specifying voltage, hertz, and amps
is attached to the product. Wiring the
• Remove pallet screws from base. Damage
dishwasher with more voltage than it is
could occur to dishwasher if screws are not
removed.
rated for may cause severe damage. To
reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
technician in accordance with all
Plumbing connections must comply with
applicable codes and standards, including
applicable sanitary, safety and plumbing
fire-rated conditions.
codes.
W A R N I N G
Electrical power must be turned off at
The dishwasher door may not stay open
circuit breaker or fuse box before making
by itself until the door panel is installed.
electrical connections. Disconnect the
Be aware of this when fastening the
electrical power supply and place a tag at
dishwasher to the cabinet.
the disconnect switch indicating that you
are working on the circuit.
It is recommended that a thorough site inspection be
Site Preparation
conducted PRIOR to unpacking and moving this appliance.
3
W A R N I N G
W A R N I N G