Table of Contents
Advertisement
Counter Balance Spring Adjustment
1
2
Disconnect cable from hook.
Increase
tension
3
Decrease
tension
Set counter balance spring connector in appropriate
location.
Note: For custom panel installation,
the door may require adjustment
to the preload of the counterbalance
springs. Follow these steps to
adjust the tension.
12
(if necessary)
2
1
Remove spring from dishwasher.
4
2
Reconnect cable to hook.
Installation
1
2
2
4
x4
3
Carefully lay dishwasher on its back and attach the kick
plate brackets. Screws for the brackets will already be
in the base. Note: Be careful not to pinch hoses or
power cord beneath dishwasher.
3
Using tie strap attached to dishwasher, band water line,
drain line, and power cord together.
5
Position unit in front of cutout.
13
2
2
To adjust the depth of the kick plate, loosen screws on
the bracket and position in the required depth. Tighten
screws and repeat for other side.
4
1
1
2
x2
Attach brackets with two screws (1 per bracket).
6
Slide unit into opening; be sure to feed water, electrical
and discharge lines into adjacent cabinet.
Advertisement
Table of Contents
