Counter Balance Spring Adjustment; Installation Procedure - Viking 200 Series Installation Manual

Counter Balance Spring Adjustment - If Necessary
a
Disconnect cable from hook.
c
Reconnect cable to hook.
16
b
Increase
tension
Decrease
tension
Set counter balance spring connector in appropriate
location.
NOTE: For custom panel
installation, the door may
require adjustment to the
preload of the counterbalance
springs. Follow these steps to
adjust the tension.

Installation Procedure

1
Carefully lay dishwasher on its back and attach the kick
To adjust the depth of the kick plate, loosen screws on
plate brackets. Screws for the brackets will already be the bracket and position in the required depth. Tighten
in the base. NOTE: Be careful not to pinch hoses or
power cord beneath dishwasher.
2
Using tie strap attached to dishwasher, band water line,
drain line, and power cord together.
4
Slide unit into opening; be sure to feed water, electrical
Using a level, adjust to appropriate height. Left and right
and discharge lines into adjacent cabinet.
17
1b
screws and repeat for other side.
3
Position unit in front of cutout.
5a
Equal distance
Up Down
adjust side to side and center adjusts front to back.
(Select models only)