FujiFilm FinePix S1 Owner's Manual page 112

Using the USB Cable and Software Included - continued
4
Plug the small plug on the cable provided into the
digital (USB) socket on the camera and then plug the
other end of the cable into the USB port on the
computer. When you switch on the computer, the
" " icon appears on the camera's rear display panel.
• Use only the special cable provided.
• When the "!BUSY" message appears on the rear display panel, this
indicates that the camera is being accessed. Never open the slot cover or
disconnect the cable while the camera is being accessed. This can
prevent correct data downloading and cause camera malfunctions.
Replacing Media (Downloading mode)
On Windows 98
Check that the camera is not being accessed, switch the camera off and
replace the media.
On Windows 2000 Professional
Check that the camera is not being accessed, click on the Eject button in the
taskbar, and then switch the camera off and replace the media.
On a Macintosh
Drag the removable disk icon on the desktop to the Trash. Once the
"REMOVE OK" message has appeared on the rear display panel, switch the
camera off and replace the disk.
• If you open the slot cover without switching the camera off, the "‹" warning
appears on the top display panel. If this occurs, switch the camera off and
then on again.
• You should use the optional AC Power Adapter AC-5VH (sold separately) and
the battery adapter. Data cannot be downloaded if the power fails during
downloading.
• The Auto Power Off function does not operate when the camera is connected
to a PC.
112
Downloading mode Shooting mode