Pad3 Pad Function; Trg1 Trigger Setup - Yamaha DTX Drums DTX502 Owner's Manual

Advanced Techniques
Setting Parameters using Menu Mode
Pad Function
Pad3
>Pad3
"Func=off
q Trigger input
This item indicates the trigger input source to which a func-
tion is to be assigned. Trigger input sources can be selected
by striking the corresponding pad or zone.
NOTE
You can also select trigger input sources by holding down the
[SHIFT] button and pressing the [<]/[>] buttons.
w Func
Pad Function allows control panel operations and the like to
be performed by striking the specified pad or zone. Use this
parameter to select the function to be performed.
Settings
off
inc kitNo
dec kitNo
inc songNo
dec songNo
inc clkNo
dec clkNo
inc tempo
dec tempo
tap tempo
clkOn/Off

song>

clk&song>
doubleBass
NOTE
Pad Function cannot be used when in Training Mode.
66
DTX502 Owner's Manual
q
snareHd
w
Description
Voices will be played in the normal way.
Increase the kit number by 1
Decrease the kit number by 1
Increase the song number by 1
Decrease the song number by 1
Increase the Click Set by 1
Decrease the Click Set by 1
Increase the tempo by 1 BPM
Decrease the tempo by 1 BPM
Tap a new tempo (page 36)
Turn the metronome on or off
Start or stop an external song
Turn the metronome on or off and simulta-
neously start or stop an external song (syn-
chronized with the metronome)
Turn the Double Bass Switch on or off (page
61)
06: Trigger Area
Trigger-related settings
Trigger Setup
TRG1
>tRG1 ¢¢¢¢¢¢¢¢¢
01:DtX522K
q
q Trigger setup
Use this parameter to select a trigger setup.
01: DTX522K, 02: DTX532K, 03: DTX542K,
04: DTX562K, 05: DTX500K, 06: DTX520K,
07: DTX530K, 08: DTX540K, 09: DTX550K,
Settings
10: DTX560K, 11: DTXP4STD (DTXPRESS
IV STD SET), 12: DTXP4SP (DTXPRESS IV
SP SET), 13: DTXPL (DTXPLORER),
14: DrumTrig, and 15–30: UserTrig
NOTE
The most appropriate trigger setup for your electronic drum kit
will be automatically selected during the Initial Setup process
(page 13). For this reason, it is usually not necessary to change
the setting on this page. However, you may decide to edit trigger
parameters after making detailed changes to the settings of indi-
vidual pads in order, for example, to add another pad or to elimi-
nate crosstalk. In such a case, you should store your settings in
a User trigger setup (numbered 15 to 30) as described below.
‚