Table of Contents
Advertisement
Reference
Utility Mode [UTILITY]
Pad Settings
Hi-Hat Settings
1 FootClosePosi (Foot Close Position)
Determines the amount of time it takes to detect a foot splash
(from the start of a downward press to the opening of the hi-
hat controller). The smaller the value, the more narrow the
"virtual" open position is. Larger values increase the size of
the gap between the top and bottom cymbals, and this can pre-
vent foot close or foot splash sounds from being produced
when you operate the pedal.
Range
-32 – +32
B FootSplashSens (Foot Splash Sensitivity)
Determines the length of time from the moment you apply a
foot-splash performance to the Hi-Hat Controller to the
moment the foot-splashed hi-hat sound is actually triggered.
For larger values, you can play the foot-splashed sound more
easily; however, slight movements of the pedal may trigger
the sound inadvertently. It is a good idea to set this parameter
to "off" if you do not play foot-splashes.
Range
off, 1 – 127
C SendHH
Determines whether or not the continuous change of the
sound generated by opening/closing the Hi-Hit cymbal (by
pressing/releasing the Hi-Hat Controller) is transmitted as
MIDI messages via MIDI OUT.
Settings
off, on
Pad Function Settings
From this display, you can assign functions other than trig-
gering the drum sound to the pad (Trigger Input Source).
1
126
DTX900 Owner's Manual
[SF1] HI HAT
2 3
1
[SF2] PADFUNC
2
1 SOURCE (Trigger Input source)
Determines the Trigger Input Source to which the specified
function is assigned. When Input Lock (page 79) is turned off,
you can select the Trigger Input Source also by hitting the
corresponding section of the pad.
Refer to the Trigger Input Source List on
Settings
page 61.
NOTE
• The Pad Function setting overcomes the Pad Song setting (page 93)
if both of them are assigned to the same Trigger Input Source.
B PadFunc
Determines the function assigned to the Trigger Input Source
specified above.
Settings
See below.
Off
No function is assigned. Normal operation.
inc kitNo.
Hitting the pad increases the Drum Kit num-
ber by 1.
dec kitNo. Hitting the pad decreases the Drum Kit num-
ber by 1.
inc chain
Hitting the pad increases the Chain Step
number by 1.
dec chain
Hitting the pad decreases the Chain Step
number by 1.
inc tempo Hitting the pad increases the value of the
tempo by 1.
dec tempo Hitting the pad decreases the value of the
tempo by 1.
tap tempo Hitting the pad three times sets the tempo
value even when the Tap display is not called
up.
clk on/off
Hitting the pad starts/stops Click playback.
Trigger Bypass Settings
1
1 TrigBypass
When this parameter is set to on, the DTX900 will not accept
any Trigger Signals coming from all Trigger Input Sources.
This parameter is useful when you want to cancel all Trigger
Signals temporarily in order to change the pad connection
setup. This parameter should be set to off normally.
Settings
off, on
[F2] PAD
[SF3] TRGBYPS
Advertisement
Table of Contents
