To Install Infrared Support - HP OmniBook 3000 - Notebook PC Manual

Using Windows 95
Installing Windows 95

To install infrared support

Requirements
OmniBook 3000 with Windows 95 installed.
HP OmniBook driver for infrared support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\WIN95\IRDA ..\FASTIR.
1. Go to the infrared drivers directory (\OMNIBOOK\DRIVERS\WIN95\IRDA) and
copy the .INF files to C:\WINDOWS\INF:
2. If prompted to overwrite old files, click Yes.
3. Reboot the OmniBook.
4. When prompted, press F2 to open the BIOS Setup Utility.
5. Go to the System Devices menu.
6. Set the Infrared Port to Enabled.
7. Set the Mode to FIR.
8. Set the Base I/O address to either 2F8 IRQ3 or 3F8 IRQ4
9. If necessary set the DMA Channel to DMA 3.
10. Save and exit the BIOS Setup Utility.
11. Select Driver from disk provided by hardware manufacturer.
12. Enter the directory of the infrared drivers
(\OMNIBOOK\DRIVERS\WIN95\FASTIR) and click OK.
13. Shutdown and restart Windows 95.
14. Go to \OMNIBOOK\DRIVERS\WIN95\IRDA and run SETUP.
15. Click Next to run the Add Infrared Device Wizard.
16. Click Next to accept the Built-In Infrared port on laptop.
17. Select SMC IrCC (Fast Infrared) Hardware and Driver, then click Next.
18. Click Next to accept the default ports (COM4 and LPT3).
19. Click Finish.
20. Run Windows Explorer.
21. From the View menu click Options.
3-10