Table of Contents
Advertisement
Power connector cable
Description
Power connector cable (includes cable and connector)
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Top cover (see
Remove the power connector cable:
1.
Turn the computer upright with the right side toward you.
2.
Disconnect the power connector cable (1) from the system board.
3.
Remove the Phillips PM2.0×4.0 screw (2) that secures the power connector cable to the base
enclosure.
4.
Remove the bracket from atop the connector (3).
Battery on page
41).
Hard drive on page
51)
Optical drive on page
Top cover on page
55))
54)
Component replacement procedures
Spare part number
621884-001
67
Advertisement
Table of Contents
