Optical Drive Connector - HP G32-200 - Notebook PC Maintenance And Service Manual

Optical drive connector

Description
Optical Drive Mounting Kit (includes SATA cable, cable bracket, optical drive bracket,
and screws)
Before removing the optical drive connector, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Top cover (see
d. USB board
e. Speaker
Remove the optical drive connector:
1. Turn the computer upright with the right side toward you.
2. Remove the tape that secures the cable to the base enclosure (1).
3. Disconnect the optical drive connector from the system board (2).
4. Remove the Phillips PM2.0×3.0 screw (3) that secures the optical drive connector to the base
enclosure.
5. Lift the bracket from the base enclosure (4).
Battery on page
Hard drive on page
Optical drive on page
Top cover on page
(USB board on page
assembly(Speaker assembly on page
41).
51)
54)
55)
61).
63).
Component replacement procedures
Spare part number
608274-001
69