Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly; Paper Is Not Cut - Canon imagePROGRAF iPF650 User Manual

Troubleshooting

Roll paper cannot be inserted into the paper feed slot

The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.

Cannot load sheets

The paper source selection is incorrect.

Paper is not cut neatly

The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
11
During cutting, printed documents fall out at
an angle.

Paper is not cut

In the printer driver, No or Print Cut Guideline is
specified in Auto Cut.
766
In the Control Panel menu, Cutting Mode is set to
Eject or Manual.
Roll paper cannot be inserted into the paper feed slot
> Problems Regarding Paper
Cause
Cause
Cause
Cause
>
Corrective Action
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Corrective Action
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use
scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the pa-
per.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
→P.759
→P.763
Corrective Action
→P.586
→P.645
→P.586
Corrective Action
iPF650