Setting The Clock - Sharp CD-BA1700H Operation Manual

SETTING THE CLOCK

In this example, the clock is set for the 24-hour (0:00) sys-
tem.
(Main unit operation)
MEMORY/SET
ON/
STAND-BY
CLOCK
TUNING/
TIME
( )
1
Press the ON/STAND-BY button to enter the stand-
by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME (
time display mode.
0:00 AM 0:00
"0:00" The 24-hour display will appear. (0:00 -
23:59)
"AM 0:00" The 12-hour display will appear. (AM 0:00
- PM 11:59)
"AM 12:00" The 12-hour display will appear. (AM
12:00 - PM 11:59)


Note that this can only be set when the unit is first
installed or it has been reset (see page 34).
5
Press the MEMORY/SET button.
6




7
8




9


or ) button to select the
To see the time display:
Press the CLOCK button.


AM 12:00
Note:


To change the clock time:
1
2
3
To change the time display mode:
1
2
10
Press the TUNING/TIME (
the hour.
Press the TUNING/TIME (
advance the time by 1 hour. Hold it down to advance con-
tinuously.
When the 12-hour display is selected, "AM" will change
automatically to "PM".
Press the MEMORY/SET button.
Press the TUNING/TIME (
the minutes.
Press the TUNING/TIME (
advance the time by 1 minute. Hold it down to change the
time in 5-minute intervals.
The hour setting will not advance even if minutes
advance from "59" to "00".
Press the MEMORY/SET button.
The clock starts operating from "0" second. (Seconds are
not displayed.) And then the clock display will disappear
after a few seconds.
The time display will appear for about 5 seconds.
The clock display will flash on and off at the push of the
CLOCK button when the AC power supply is restored
after a power failure occurs or after the AC power lead is
disconnected. If this happens, follow the procedure below
to change the clock time.
Press the CLOCK button.
Within 5 seconds, press the MEMORY/SET button.
Perform steps 6 - 9 above.
Perform steps 1 - 2 in "RESETTING THE MICROCOM-
PUTER", on page 34.
Perform steps 1 - 9 above.
or ) button to adjust
or ) button once to
or ) button to adjust
or ) button once to