How To Use The Built-In Timer - Sharp CD-BA1700H Operation Manual

HOW TO USE THE BUILT-IN TIMER

Timer playback
The unit will turn on and play the selected source at the pre-
set time.


Before setting the timer, make sure that the clock setting
is correct (page 10).
(Main unit operation)
ON/
STAND-BY
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the CD, TUNER (BAND), TAPE (1
VIDEO/AUX button to select the desired function,
and then adjust the sound volume using the VOL-
UME buttons.
3
Press the TIMER/SLEEP button repeatedly until a
white " " is displayed.


The timer set indicator will flash.
4
Press the TUNING/TIME (
hour start time, then press the MEMORY/SET but-
ton.
TUNER/(BAND)
TIMER/
SLEEP
CD
TAPE
(1 2)
VIDEO
/AUX
TUNING/
TIME
(
)
5
2) or


6


7
or ) button to set the
To cancel timer operation:
Press the ON/STAND-BY button to turn the power on.
To change the programmed contents:
Start again from step 1.
Notes:




30
MEMORY/SET
VOLUME
Press the TUNING/TIME (
minute start time, then press the MEMORY/SET but-
ton.
The unit will enter the stand-by mode automatically, and
the timer set indicator will light up.
When the preset time is reached, the timer playback
will start.
The volume will increase gradually.
If you select CD or TAPE, the unit will enter the
stand-by mode after the playback. If you select
TUNER or VIDEO/AUX, it will enter the stand-by
mode one hour after the timer playback starts.
When performing timer playback using an external unit
connected to the VIDEO/AUX sockets, only the power of
the main unit will enter the stand-by mode automatically.
(The power of the external unit will not be turned off.)
Once the time is set, the setting will be retained until a
new time is entered.
or ) button to set the