Sharp CD-BA1700H Operation Manual page 17

(Continued)


Preset tuning
You can store up to 40 stations in memory (40 stations con-
sisting of any combination of FM and AM stations) and
recall them at the push of a button.
To enter stations into memory:
1
Perform steps 1 - 5 in the "Tuning" section.
2
Press the MEMORY/SET button.


"MEMORY" and the preset channel number will flash.
3
Within 30 seconds, press the PRESET (
ton to make the preset channel number flash in the
display.


Store the stations in memory, in order, starting with pre-
set channel 1.
4
Within 30 seconds, press the MEMORY/SET button
to store that station in the selected station preset
number memory.


If the "MEMORY" and preset number indicators go out
before the station is memorised, repeat the operation
from step 2.
5
Repeat steps 1 - 4 to set other preset stations, or to
change a preset station.
Notes:


When a new station is stored in the selected station pre-
set number memory, the contents previously memorised
will be erased.


To store an RDS station in memory, perform steps 2 - 4
whilst the RDS station name is displayed.
(Main unit operation)
2,4
To recall a memorised station:
Press the PRESET ( or ) button for less than 0.5 sec-
onds to select the desired station.


The stations (preset channel number, frequency and fre-
quency band) which have been stored in memory will
appear in the display in numerical order, irrespective of
the frequency bands.
Note:
When searching for a memorised station, do not press the
PRESET button for more than 0.5 seconds. When the PRE-
SET button is pressed for more than 0.5 seconds, the unit
will enter the preset memory scan mode.
Backup function:
The backup function protects all station presets for a few
hours should there be a power failure or the AC power lead
is removed from the AC socket.
To erase all the contents in the preset memory:
1 Press the ON/STAND-BY button to enter the stand-by
mode.
2 Press the ON/STAND-BY button whilst holding down the
TUNER (BAND) button and the X-BASS/DEMO button.


"TUNER CL" will appear.


After performing this operation, all of the preset memory
information will be erased.


Preset memory scan
The stations saved in the preset memory can be scanned
or ) but-
automatically.
1
To scan the preset stations, press the PRESET (
) button for more than 0.5 seconds.


The station preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
memory scan at the desired station.
3
Note:
When the preset memory does not have any stations stored
in it, the preset memory scan will not function.
17
or ) button again to stop the
PRESET( )
PRESET
( )
or