Getting Started; Control Panel - Ricoh Type 2075 Operating Instructions Manual

Control Panel

This illustration shows the control panel when options are installed.
{ { { { Use Tools/Counter} } } } key
1.
Use to change default or operation pa-
rameters according to the operating con-
ditions.
2.
Indicators
Display errors and the machine status.
See "Control Panel", General Settings
Guide.
m: Data In Indicator
L: Service Call indicator
x: Misfeed indicator
M: Open Cover indicator
d: Add Staple indicator
D: Add Toner indicator
3.
Display panel
Displays the operation status and mes-
sages.
{ { { { Check Modes} } } } key
4.
Press to check the destinations which are
currently selected.
{ { { { Program} } } } key
5.
Use to register settings used frequently as
a program or to recall the registered pro-
gram.

1. Getting Started

{ { { { Clear Modes} } } } key
6.
Press to clear the current settings.
{ { { { Energy Saver} } } } key
7.
Press this key to begin warm-up.
Pressing this key again while in warm-up
mode cancels warm-up.
Note
❒ This key is inactive while scanning or
setting scanner defaults.
{ { { { Interrupt} } } } key
8.
Press this key to interrupt the scanner
mode and to activate the copy mode.
9.
Main power indicator and power
indicator
The main power indicator lights up when
the main power switch is set to on. The
power indicator lights up when the ma-
chine is on.
Important
❒ Do not turn off the main power
while the power indicator is lit or
blinking. Doing so may cause a
failure of the hard disk.
AFD003S
3