Bulk Oil Systems - Frymaster OCF30 Series Installation & Operation Manual

1. Open the cabinet and slide the JIB from
the cabinet (see Figure 3).
Figure 3
3. With the jug upright remove the cap and
foil seal (see Figure 5).
Figure 5
WARNING:
HOT or USED oil to a JIB.
3.4.4

Bulk Oil Systems

Instructions for installing and using bulk oil systems are found in Appendix C located
at the rear of this manual.
Do not add
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 4).
4. Put the tube in the new full container (see Figure 6).
5. Slide the JIB onto the shelf inside the fryer cabinet
(as seen in Figure 3).
6. Press and hold the orange JIB reset switch three (3)
seconds to reset the top off system. (see Figure 7).
Image and location may differ
3-6
Figure 4
Figure 6
Figure 7
from photo.