Connecting Vc-231 / Vc-234; Connecting Standalone Pc - Planet vc-231 User Manual

3.2 Connecting VC-231 / VC-234

3.2.1 Connecting Standalone PC

Refer to the following procedures to setup the VC-231 to a
standalone PC.
1. Set the VC-231 to be CO mode or CPE mode from the DIP
switch at the rear panel.
2. Power on the VC-231 by connecting its power source.
3. Power LED will illuminate.
4. Use one RJ-11 wire and make a connection between VC-231
and "Line" port of splitter from VC-231 package.
5. Connect VDSL line from another VDSL device to DSL port of
the splitter that connects to VC-231 VDSL port.
6. LNK LED will from blinking to illuminate.
7. Connect telephone to the PHONE port of the splitter that
connects to VC-231 VDSL port.
8. Connect VC-231 Ethernet port to PC Network Interface Card
(NIC) via regular Cat. 5 cables.
RJ-11 Line Cord
Phone
RJ-11 Line Cord
RJ-11 Phone Jack
Figure 3-3: Connecting Standalone PC
Splitter
Phone
VDSL
VC-231
TP
RJ-45 Cat.5
Twisted Pair Cable
100Base-TX UTP
Telephone wire
PC
23