1.1 GENERAL SPECIFICATIONS (CONT'D)
Specification
Electrical Characteristics
Print method
Head density
Printable Area
Print speed
CPU
Onboard Memory
Acceptable Print Area
Memory cartridge
Print Characteristics
Print Format
Paper Thickness
Paper Size
*in continuous mode
Label Pitch Sensor
Carbon ribbon
Dimensions
Thickness of base material
Color
Winding direction
LM Basic 408e/412e Operator's Manual
Model LM408e
8 dots/ mm (203 dpi)
W104 mm x pitch 1249 mm (203dpi)
(No printing within 3 mm from the inner edge)
2 to 6 inches/sec @203dpi (adjustable in 1-inch/sec increments)
Note:
Maximum speed depends on print resolution, and may be further dependent on the type of
print layout, paper, or carbon ribbon in use.
Expandable Memory: 2x4MB Expandable memory
Interface Buffer: 2.95MB for Receive Buffer, "Near Full" warning at 2MB mark.
(Expandable Pitch (using AX command): 356mm
(Expandable Pitch
(using EX command): 1249mm
Transmitted from host (computer)
0.08 mm to 0.26 mm supported.
Note: Be sure to use only printer supplies manufactured or certified by SATO.
Width: 10mm to 112mm (13 mm to 115 mm including liner)
Pitch 15mm to 1252mm (18 mm to 1255 mm including liner)
Reflective type (I-mark) and Transmissive type (Gap)
Be sure to use the specified carbon ribbons manufactured or specified by SATO
W25mm to 111m by 450 m/roll
4.5 µm
Black (standard), also red, blue, purple, and green
Face-In winding
Thermal transfer or direct thermal
32-bit RISC
Main Memory: 2MB FLASH ROM
Standard width: 104mm
Standard pitch:178mm
(using EX command): 833mm
Not accepted
Section 1: Introduction
Model LM412e
12 dots/ mm (305 dpi)
(Expandable Pitch
Page 1-3