SATO CLLM Basic 412e Operator's Manual page 21

2.1.2 PARTS IDENTIFICATION (CONT'D)
IDENTIFYING THE MAIN PRINTER PARTS
LCD screen
Icons, prompts and system messages
are displayed here.
LINE button
Takes the printer ONLINE (to proceed with printing) or
OFFLINE (to perform configuration or other settings)
Status LED
Lights up and flashes to indicate exchange of data.
DIP switch panel
LM Basic 408e/412e Operator's Manual
View of Front Panel
8888888888888888
8888888888888888
LINE STATUS
PRINT OFFSET
DSW
FEED
PITCH
FEED button
. Feeds the label forward. When it is pressed once,
the equivalent of a sheet of paper or label is ejected.
*There are times when the paper is not aligned prop-
erly when power is turned on or when the paper was
set. In this case, always press the FEED button to
align the paper properly.
Adjustment Potentiometers
PRINT: Adjusts the print darkness (print den-
sity).
OFFSET: Adjusts the stop position offset values
for the cutter, peeler and tear off modes (cutter,
peeler must be installed).
PITCH: Adjusts the vertical print position with
reference to the top edge of a label.
Section 2: Installation
Page 2-7