Print Speed; Pitch Offset; Cancel Print Job - SATO CLLM Basic 412e Operator's Manual

3.4 NORMAL MODES (CONT'D)

3.4.4 Print Speed

Pressing LINE repeated cycles through the various available
speeds. The slowest speed is 2ips, while the highest speed is 6ips.
The default speed for the LM Basic 408e is 4ips.
Press the FEED button to select a print speed. The screen for Pitch Offset appears.

3.4.4 Pitch Offset

This screen lets you adjust the pitch offset by up to +/- 49mm.
The default value is 0.
Press the LINE button to shift the cursor from left to right.
When the cursor is over the "+" or "-" symbol, press the FEED button to cycle it between "+" and
"-". The cursor then moves one step to the right.
When the cursor is over one of the numeric digits, press the FEED button to cycle it between "0"
and "9" to form the first or second digit of the desired pitch offset value.
Finally, press the FEED button to proceed to the screen for Cancel Print Job.

3.4.5 Cancel Print Job

This screen lets you cancel the current print job and all received
data for the label.
Press the LINE button to switch the cursor between YES and NO.
When the cursor is over the desired option, press the FEED button to confirm the setting.
If you selected YES, the print job is cancelled, and the following
screen appears for about three seconds:
The screen then goes back to ONLINE status.
LM Basic 408e/412e Operator's Manual
Section 3: Configuration and Operation
PRINT SPEED
2 3 4
PITCH OFFSET
CANCEL PRINT JOB
YES
CANCEL PRINT JOB
COMPLETED
5 6
+ 00mm
NO
Page 3-9