Toshiba e-STUDIO2500c Operator's Manual page 94

2 HOW TO MAKE COPIES
Copying on back sides
When you want to copy on the both sides of a type of paper that is unacceptable for
automatic duplex copying, such as THICK4, select a media type for the copy paper
and make a copy on one side of it. Then copy on the other side by selecting (BACK).
Be sure to select the appropriate media type to make copies in the optimal image
quality.
e.g.: When making a 2-sided copy on a THICK4 paper
1. Place a sheet of THICK4 paper on the bypass tray.
2. Select THICK4 and make a 1-sided copy.
3. Place the paper copied at step 2 on the bypass tray again with its blank side
4. Select THICK4 (BACK) and make a copy.
The paper type which has been set can be confirmed with the touch panel.
PLAIN
THICK1
THICK1 (BACK)
THICK2
THICK2 (BACK)
THICK3
THICK3 (BACK)
THICK4
THICK4 (BACK)
6
Press the [START] button on the control panel.
When you copy on OHP films, remove the copied OHP films, which have exited on to the
receiving tray one by one. When the films pile up, they may become curled and may not
be projected properly.
92 Bypass Copying
face down.
If you place the paper on the bypass tray with its top to bottom direction
unchanged, the original is copied in 'open to left', and if you place it with its top
to bottom direction changed, the original is copied in 'open to top'.
- When you want to make 2-sided copies on PLAIN, RECYCLED PAPER,
THICK1, THICK2 or THICK3, use the Automatic Duplexing Unit of the
equipment.
- Place THICK2 and THICK3 in either the Drawer 1 or 2 of this equipment.
- OHP films are not acceptable for 2-sided copying.
-- TRANSPARENCY
RECYCLED PAPER
SPECIAL1
SPECIAL1 (BACK)
SPECIAL2
SPECIAL2 (BACK)