Blueant Q1 User Manual page 41

Function Button
"Vol +"
Turn LEDs On or
and "Vol -"
Off
Save the last "Vol -"
incoming call in
one of the Q1's
speed dials
"Vol +"
Hold current call
and answer a
second incoming
call
End current call "Vol -"
and answer a
second incoming
call
Hold current call "Vol +"
and switch to the
call on the other
line
Call Conference
How Long When
Hold for 1 Idle
second
Hold for 1 Standby
second
Hold for 1 3 Way Call This function is only available if your phone
second
Hold for 1 3 Way Call This function is only available if your phone
second
Hold for 1 3 Way Call This function is only available if your phone
second
Hold for 3 3 Way Call This function is only available if your phone
seconds
Notes
This function is only available when the
headset is in Idle mode. It is not available
when the headset is in Standby mode, so
you will need to disconnect from all paired
mobile devices before using this button
combination.
You can turn off the LED without
disconnecting by using the "LED Light"
command on the "Settings Menu".
Please note that this button combination
also turns the voice control on or off (but
with a longer button press). You must
therefore make sure you release the
volume buttons after 1 second.
This function is not available if you have
turned off voice control.
For more information about storing
numbers in the Q1's speed dials, see
"Setting Up Speed Dials" (page
and phone network supports 3 way calling.
and phone network supports 3 way calling.
and phone network supports 3 way calling.
and phone network supports 3 way calling.
23).
41