Table of Contents
Advertisement
My Phone Does Not Automatically Reconnect to the Q1
Once you have paired your phone with the Q1, they should automatically reconnect every time they
come back into range with each other.
By default, some phones will prompt you to confirm whether you want to accept the connection from
the Q1. If your phone keeps prompting you about the connection to the Q1, then you should change the
setting on your phone so that it treats the Q1 as a trusted or authorized connection.
Configuring Your Phone To Automatically Reconnect to the Q1
1. Go to your phone's Bluetooth menu.
2. Locate the BlueAnt Q1 in the list of paired devices, and go to the options or device property
settings.
3. The exact option to change will depend on your phone model, but look for the option to set this
device as an "authorized device", add it to your phone's list of "trusted devices", or change the
"trusted" setting for this connection to "yes".
The Q1 Keeps Switching Itself Off
This is likely to be because the Q1's battery is running low. If the battery gets very low, the Q1
automatically turns itself off. You should charge your Q1 using the supplied USB cable and adapter.
The Q1 does not Respond to my Voice Commands
If you find that the Q1 does not respond to your voice commands, try the following tips:
• Make sure you say the command clearly, speaking at a consistent speed.
• If the headset does not respond, repeat the command.
• There is a microphone on the bottom tip of the Q1. Make sure that it is pointing towards your
mouth and that it is not covered or muffled by your face.
• Speak louder than any background noise.
• Try changing the Q1's sensitivity level: see
• If you are in a very noisy place, you may find that it is easier to answer a call using the Q1
buttons: click the BlueAnt button to answer the call, or double click it to reject the call.
"Sensitivity Level" (page
26).
32
Hide quick links:
Advertisement
Table of Contents
