Blueant Q1 User Manual page 38

Function Button
Switch the Q1 Off
Enter Pairing
Mode
Volume Up "Vol +"
"Vol -"
Volume Down
Activate "Say
A Command"
(Voice
Recognition)
Answer a Call
End a Call
How Long When
Hold for 3 Idle,
seconds Standby
Hold for 6 Off
seconds
Click Idle,
Standby,
Ringing,
Active Call,
3 Way Call
Click Idle,
Standby,
Ringing,
Active Call,
3 Way Call
Click Idle,
Standby
Click Ringing
Click Active Call,
3 Way Call
Notes
You will hear a sound indicating that the
Q1 is switching off.
You cannot turn the Q1 off during a call, so
you must end the call first. If you just want
to revert to using your phone for the call,
you can disconnect the Q1 during the call
instead.
If the Q1 is switched on, then you can enter
pair mode by using the voice command
"Pair Me" instead.
The Q1 will beep when it reaches the
maximum volume.
The Q1 will beep when it reaches the
minimum volume.
You need to activate voice recognition in
order to use one of the voice commands
(the Q1 will ask you to "Say A Command").
Click the BlueAnt button again to cancel,
or wait a few seconds and the voice
recognition will automatically cancel if you
do not say a command.
You can also answer or reject a call using
the voice commands.
The call will also end if the other party
terminates it (you do not need to click
anything if the other party ends the call).
Please note that this button press changed
in firmware version 8.19. If you have an
older firmware release on your Q1, then
you end a call by double clicking the
BlueAnt button.
38