Switching The Q1 On And Off - Blueant Q1 User Manual

To listen to audio, simply start playing audio on your A2DP device: the sound will automatically
transfer to the Q1.
Please note that audio streaming with A2DP was added to the Q1 in firmware version
8.19. If you have an older version of the firmware installed on your Q1, then you will
need to update your Q1 to the latest firmware release in order to use A2DP streaming.
You can check what version of the firmware is installed on your Q1 by looking at the
version number shown in the Bluetooth pairing list on your phone.
To update your Q1, please go to
This will give you access to the downloads area where you can download, install, and
run the BlueAnt Q1 Updater software.

Switching the Q1 On and Off

To switch the Q1 on or off, hold down
sound indicating that the Q1 is starting up/shutting down).
You can also switch the Q1 off by using the voice command "Switch Headset Off".
If you are on a call, you will have to end the call first before you can turn the Q1 off.
register.blueantwireless.com
(the BlueAnt button) for about 3 seconds (until you hear a
to register your Q1.
15