Boot Options; Bios Serial Console; Configuring Lockstep Memory - HP ProLiant ML100 Series User Manual

NOTE:
automatically configure the array. You must run ORCA to configure the array
Drive configuration
2
3
4
6
8
To ch ange any ORCA default settings and override the auto-configuration process, press the F8 ke
prom pted.
To ch ange any default settings in the auto-configuratio
and primary boot controller), execute RBSU by pressing the F10 key when pro
selected, exit RBSU and allow the server to reboot automatically.
For more information on RBSU, see the HP ROM-Based Setup Utility User Guide on the Documentation CD
or the HP website (http://www.hp.com/support/smartstart/documentation).
Boot options
Near the end of the boot process, the boot options screen is displayed. This
seconds before the system attempts to boot from a supported boot device. D
the following:
•
Access RBSU by pressing the F10 key.
•
Force a PXE Network boot by pressing the F12 key.
BIOS e S rial Console
BIOS Serial Console allows you to configure
remotely through a serial connection to the server C
does not require a keyboard and mouse.
For more information about BIOS Serial Console, see the BIOS Serial Console User Guide on the
Documentation CD or the HP website (http://www.hp.com/support/smartstart/documentation).
Confi guring lockstep memory
To configure Lockstep memory:
Install the required DIMMs
1.
Access RBSU by pressing the F10 key during power-up when the prompt is displayed.
2.
Select Advanced.
3.
Select Chipset Configuration.
4.
In Memory Mode, select Lockstep.
5.
If the boot drive is not empty or has been written to in the past, ORC
RAID function (smart
array controller)
0 or 1
5
6 or 10
50
60
("Installin g
R AID function
(s oftware)
0 or 1
—
10
—
—
n process (such as the settings operating system
the serial port to view POST error messages and run RBSU
OM port. The server that you are remotely configuring
DIMMs" on page 23).
A does not
settings.
mpted. After the settings are
screen is visible for several
uring this time, you can do
Software and configuration utilities 31
y when