Retaining The Recovery Key/Password - HP ProLiant ML100 Series User Manual

Install the TPM board. Press down on the connector to seat the board.
6.
Install the TPM security rivet by pressing the rivet firmly into the system board.
7.
Install the access panel.
8.
Do one of the following:
9.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 6).
10.

Retaining the recovery key/password

The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
Hardware options installation 28