HP Pavilion zt1100 Service Manual page 70

Symptom Call Center:
Suggestions
Battery indicator is Time Remaining is an
inaccurate. estimate based on how much
power the notebook is using
at that moment. It therefore
depends on the current task,
and assumes power will be
used at the same rate until
the battery runs out. So, for
example, if the notebook is
performing a task requiring a
good deal of power (such as
reading from a CD or DVD),
the value will probably show
too little time remaining.
Standby/resume
General problems Close all applications before
entering (or allowing
notebook to enter) standby or
hibernation.
If problem appears after
installing new software
(including drivers), uninstall
that software. Contact
software vendor for additional
support.
Notebook resumes Notebook can take a minute
slowly from standby or longer to resume if
network card is installed.
Blinking cursor appears while
system is loading and
checking hardware and
network connections. When
hardware is reinitialized,
Windows desktop appears.
Does not go on The notebook won't suspend
standby as if it has an active connection
expected. to another computer.
If the notebook is busy, it
normally waits to finish the
current operation before
suspending.
Does not Make sure hibernate support
automatically enter is enabled in Power Options
hibernation as in Control Panel. Also, make
expected. sure the hibernate timeouts
(Power Schemes tab) for AC
and battery power are not set
to Never.
Notebook with Disable Bluetooth. If
Bluetooth won't Bluetooth device is
enter standby or transmitting, notebook may
hibernation. not be able to enter standby
or hibernation.
3-8 Troubleshooting and Diagnostics
Repair Center: Repair Center:
Likely Causes Comments
HP Pavilion zt1100/xz100 Omnibook xt1000