HP Pavilion zt1100 Service Manual page 60

Component
Doors, PCMCIA
Fan
Guide, hard disk drive
Heatsink
Keyboard
Module, CPU
PCA, CD player
PCA, inverter
PCA, motherboard
PCA, USB
2-38 Removal and Replacement
Removal Procedure
Plug-in module (page 2-5).
Hard disk drive (page 2-6).
Keyboard cover
(page 2-9).
Keyboard (page 2-11).
SDRAM modules
(page 2-13).
Mini-PCI card (page 2-16).
Display assembly
(page 2-18).
Fan and heatsink
(page 2-22).
CPU module (page 2-25).
Top case (page 2-27).
Hinge saddles
(page 2-30).
Motherboard (page 2-32).
See page 2-22.
Keyboard cover
(page 2-9).
Keyboard (page 2-11).
Display assembly
(page 2-18).
Top case (page 2-27).
See page 2-22.
See page 2-11.
See page 2-25.
Keyboard cover
(page 2-9).
Keyboard (page 2-11).
Display assembly
(page 2-18).
Top case (page 2-27).
See page 2-20.
See page 2-32.
Keyboard cover
(page 2-9).
Keyboard (page 2-11).
Display assembly
(page 2-18).
Top case (page 2-27).
Hinge saddle, left
(page 2-30).
Additional Steps
See Figure 2-25 on page 2-35.
Remove the retaining screws, and lift the guide off of
the motherboard.
Remove both retaining screws, and lift the PCA out of
the top case.
Reassembly Notes: Make sure the alignment holes in
the PCA (at the left end and above the right screw) fit
over the corresponding posts in the top case. Make
sure the PCA's ribbon cable is securely connected to
the PCA.
Carefully lift the PCA off of its connector and out of the
notebook.
Reassembly Notes: Make sure the headphone jack
fits through its opening in the bottom case, and that
the PCA is set securely on its connector.
HP Pavilion zt1100/xz100 Omnibook xt1000