Table of Contents
Advertisement
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
13. Check the " Use the following IP address " check box, as shown below.
Figure C-7. Internet Protocol (TCP/IP) Properties Dialog (sample)
14. Set the IP Address to 192.168.0.191 .
15. Set the Subnet Mask to 255.255.255.0 .
16. Set the Default Gateway to 192.168.0.1 .
17. When complete, click OK to close the dialog, then click OK to close the Local
18. (Optional). Click Start > Run to display the Run Dialog .
142
Note
The static IP address shown above is within the unit's user-
defined IP address range. If this address has already been
assigned to another device, select a different IP address
within the following range: 192.168.0.191
Area Connection Properties Window.
a.
In the Open field, type cmd , then click OK to open a DOS command
window.
b.
In the DOS command window, type ipconfig , and verify that the new IP
address is correct.
c.
Close the DOS command window.
→
192.168.0.240 .
PresentationPRO-II • User's Guide
Advertisement
Table of Contents
