Barco PresentationPRO-II User Manual page 115

6. Operations
5.
oÉãçîáåÖ=~=mfm=Ñêçã=mêçÖê~ã
Use the following steps to remove a PIP from Program:
1.
CLEAR
2.
3.
4.
`~åÅÉääáåÖ=~=mfm=qê~åëáíáçå
Use the following steps to cancel a PIP transition.
1.
`Ü~åÖáåÖ=~=mfm=íç=~=hbv
Use the following steps to change a PIP to a Key.
1.
2.
3.
PresentationPRO-II • User's Guide
Adjust the PIP's size, position, border, shadow, source image, cropping and
"special effects" as desired. Refer to the "
Tip Ensure that you establish the PIP's initial size and position
before your live event begins.
Ensure that you have preset the desired transition type and rate. Refer to the
" Working with Transitions
In the Layer Functions Section , ensure that the PIP button is blinking. If not,
press PIP to display the PIP Adjustment Menu . On the Source Selection Bus ,
the source associated with the PIP will be lit solid.
In the Layer Functions Section , press CLEAR to "pend" the removal of the PIP.
The CLEAR button will blink to indicate that the operation is pending.
In the Layer Functions Section , press TRANS . The TRANS button lights during
the interval, and at the conclusion of the transition, the Home Menu appears.
Assumption : A PIP transition has been selected, and the PIP button is
blinking.
In the Layer Functions Section , press PIP . The button stops blinking, and the
pending transition is cancelled. Please note:
~
If there is no source currently on Program, the PIP button turns off.
~
If there is a source currently on Program, the PIP button stops blinking
but remains lit.
Assumption : A PIP is currently on Program.
Ensure that you have preset the desired transition type and rate. Refer to the
" Working with Transitions
In the Layer Functions Section , press KEY . Please note:
~
The KEY button blinks and the PIP button remains lit solid.
~
The Key Menu appears, and the source associated with the PIP lights
solid on the Source Selection Bus .
If desired, select a new key source on the Source Selection Bus . The pending
source blinks and the current PIP source remains lit solid.
Note If you do not select a new source, the current source will be
used. It will transition off as a PIP, and back on as a Key.
Modifying PIPs
" section on page 115 for details.
" section on page 115 for details.
Working with Layers
" section on page 104.
103