Setting Up The Background; Programming Edid; Using A Matte Color As The Background; Using The Dvi Input As The Background - Barco PresentationPRO-II User Manual

5. System Setup
pÉííáåÖ=ìé=íÜÉ=_~ÅâÖêçìåÇ
With PresentationPRO-II, you can use the DVI input, a matte color, or a still frame as the
background source. Please note:
•
•
•
Select the procedure below for the type of background that you wish to set up:
•
•
•
•
mêçÖê~ããáåÖ=bafa
The EDID (Extended Display Identification Data) programming procedure is a prerequisite
for using a live DVI background or for using the DSK. The procedure guarantees proper
communications at the preferred resolution between PresentationPRO-II's DVI input and
your external computer.
Use the following steps to program the PresentationPRO-II EDID:
1.
2.
3.
4.
5.
6.
7.
8.
9.
PresentationPRO-II • User's Guide
The system has one DVI connector ( BG/DSK ) that can be used for either the
Background or the DSK — but not both simultaneously.
The BG/DSK input (along with a scaled PIP image) is the source of still frames
that can be captured and used as the background.
The function of the BG/DSK input is determined by the " Mode " line on the BG/
DSK Input Setup Menu . When set to BG , the background setup procedures
outlined below apply.

Programming EDID

Using a Matte Color as the Background

Using the DVI Input as the Background

Using a Still Frame as the Background

Ensure that the PresentationPRO-II output format matches your projector's native
resolution. Refer to the " Output Setup
Ensure that the computer (or external equipment) that you wish to use as a
background source is capable of supporting the selected output resolution.
From the HOME MENU , press { SYSTEM } > { EDID } to display the EDID DVI Input
Format Menu .
Note the Current line, which displays the current EDID video format that resides
in PresentationPRO-II memory. If this format is already set to the desired
resolution, no EDID programming is required. You can exit this procedure, and
continue with other background setup steps as needed.
If a new resolution is required, use the ADJ knob to adjust the Format to the
preferred setting at which you want to program the EDID.
Press { PROGRAM EDID } to program EDID with the new selected video format. A
warning message will be shown. Press { YES } to continue.
Once EDID programming is complete on PresentationPRO-II, power down the
external computer and power it back on.
On your PC's desktop, right-click to display the Display Properties Window .
Select the Settings Tab , and set the resolution to match that which you just
programmed into EDID.

Setting up the Background

" section on page 88 for instructions.
93