Pc Ethernet (Hub) Interface Enable/Disable - Avaya 4600 Series Installation Manual

PC Ethernet (Hub) Interface Enable/Disable

Use the following procedure to enable or disable the hub interface.
The default for the hub interface is enabled.
The 4602 and 4690 telephones do not have Ethernet PC interfaces, so this
procedure does not apply to those phones.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate of
the telephone:
Mute 4 6 8 # (Mute I N T #)
Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630 and 4630SW IP Telephones do not have a dedicated Hold
button; for all other 4600 Series IP Telephones, pressing the Hold button instead of
the Mute button will also work.
One of the following texts is displayed left-justified at the top of the display, depending on the
current value of the hub:
If PHY2=enabled:
If PHY2=disabled:
2. Press the 1 or 0 button to enable or disable the hub interface respectively, or the # button to
leave the current value.
The following text is displayed left-justified at the top of the display:
Save new value?
*=no #=yes
*
Press the button to terminate the procedure, or the # button to save the new values.
If you press the # button, the following text is displayed.
New value
being saved
The new values are saved, and the user interface is restored to its previous state.
PHY2=enabled
0=disable #=OK
PHY2=disabled
1=enable #=OK
PC Ethernet (Hub) Interface Enable/Disable
Local Administrative Options
3
3-9