Horizon Fitness GOAL GS 1035T User Manual page 6

AS SE MB LY S TEP 3
HARDWARE BAG 3 CONTENTS :
A Open HARDWARE BAG 3.
B With running deck in lowered position, place CONSOLE on upright masts. Align the brackets
that are underneath the console with the top holes of the upright masts.
C To assemble the LEFT CONSOLE MAST to the CONSOLE, insert 1 BOLT (G), 1 SPRING
WASHER (H) and 1 FLAT WASHER (B) into the 2 holes in the LEFT CONSOLE MAST and
lightly tighten.
ep4
D Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLES. Carefully tuck
wires in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.
E Repeat STEP C above to attach the RIGHT CONSOLE MAST to the CONSOLE.
T-Wrench 6mm(M8 screw)
F Leave console bolts loose until after step 4 is completed.
f8.2Xf20X1.8t
Flat Washer
10
Spring Washer M8
GS_1035T_Treadmill_Rev.2.3.indd 10-11
BOLT (G) SPRING WASHER (H)
20 mm 20 mm
Qty: 4 Qty: 4
CONSOLE CABLES
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
CONSOLE MAST
FLAT WASHER (B)
SPRING WASHER (H)
BOLT (G)
1PCS
4PCS
4PCS
ASS EMBLY STEP 4
HARDWARE BAG 4 CONTENTS :
FLAT WASHER (B)
20 mm
Qty: 4
BOLT (K)
SPRING WASHER (M)
* NOTE: Be
careful not to
pinch any ARC WASHER (L)
wires while
CONSOLE MAST
CONSOLE MAST
attaching the
console.
A Open HARDWARE BAG 4.
B Align SUPPORT BAR with holes in CONSOLE MASTS.
C Insert BOLTS (I) into all 4 holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
D Tighten all console bolts (Step 3) and support bar bolts (Step 4) completely.
BOLT (I)
15 mm
Qty: 4
SUPPORT BAR
BOLT (I)
11
6/13/07 11:18:42 AM