Horizon Fitness HORIZON CT5.0 User Manual page 6

AS SE MB LY ST EP 2 ( C O NT INUED)
HARDWARE BAG 2 CONTENTS:
BOLT (D)
Qty: 1
ELEVATION FRAME
A Insert 1 BOLT (D) and 1 FLAT WASHER (E) through
RIGHT CONSOLE MAST followed by 1 WAVY WASHER (F)
and attach to MAIN FRAME.
B Unscrew PRE-ATTACHED NUT and remove from RIGHT
LINKAGE ARM and discard. Carefully move RIGHT LINKAGE
ARM and PRE-ATTACHED TEFLON WASHER into position
and attach to ELEVATION FRAME.
NOTE: While holding RIGHT CONSOLE MAST in the
upright position, tighten PRE-ATTACHED BOLT using
T-wrench to attach RIGHT LINKAGE ARM.
C Cut band holding FOOT LOCK LATCH assembly. Lift the
RUNNING DECK until lock latch on side of treadmill is
fully engaged.
D Remove CONSOLE from box and place out of the way.
E Lower the treadmill RUNNING DECK from the folded
position by stepping on LOCK LATCH on lower right side.
10
CT5.0_Rev.1.1.indd 10-11
FLAT WASHER (E) WAVY WASHER (F) LOCK LATCH PIN (G)
27 mm 29 mm Qty: 1
Qty: 1 Qty: 1
CONSOLE CABLE RIGHT CONSOLE MAST
MAIN FRAME
WAVY WASHER (F)
FLAT WASHER (E)
BOLT (D)
PRE-ATTACHED NUT
RIGHT LINKAGE ARM
PRE-ATTACHED
TEFLON WASHER
PRE-ATTACHED BOLT
FOOT LOCK LATCH
*
NOTE: If you have attempted to
move the treadmill from the box
and the machine has sprung
open and cannot be assembled,
refer to the troubleshooting
section in order to restore the
treadmill to its proper position.
1
3
ASSEMBLY STEP 
HARDWARE BAG  CONTENTS :
BOLT (H)
20 mm
Qty: 4
A Open HARDWARE BAG .
B With running deck in lowered position, place CONSOLE on the console masts. Align the
brackets that are underneath the console with the top holes of the console masts.
C To assemble the CONSOLE to the LEFT CONSOLE MAST, insert 1 BOLT (H),
1 SPRING WASHER (I) and 1 FLAT WASHER (B) into the 2 holes in the
LEFT CONSOLE MAST and lightly tighten.
D Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wire
in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.
E Repeat STEP C above to assemble the RIGHT CONSOLE MAST to the CONSOLE.
2
SPRING WASHER (I) FLAT WASHER (B)
15 mm 20 mm
Qty: 4 Qty: 4
CONSOLE CABLE
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
CONSOLE MAST
FLAT WASHER (B)
SPRING WASHER (I)
BOLT (H)
11
6/3/08 8:39:41 AM