Show Command - Planet FSD-804PS User Manual

Set VLAN(n)
Set PoE[n]
Set VLAN mode
Set PVID
Set IP xxx.xxx.xxx.xxx, mmm. mmm,
mmm, mmm, ggg.ggg.ggg.ggg
Set Pass
Factory Default
Reboot
Logout
Notice:
Only accept command in lowercase letter under console interface.

4.4.2 Show command

From the main menu screen
appears.
Configure VLAN group 1-8
Configure per PoE port
Disable or enable Port-based VLAN function
Assign PVID on each port
Assign IP address, subnet mask, gateway of FSD-804PS
Change the default password of FSD-804PS, the maximum length is 4
Reset the FSD-804PS to factory default mode
Reboot the FSD-804PS
Logout console interface of FSD-804PS
Table 4-1 Detail description of FSD-804PS available commands
(see Figure 4-3), input "show" and press enter. The show command list screen in
Figure 4-5 Show command list screen
characters
Figure 4-5
- 15 -