Disclaimer PLANET Technology does not warrant that the hardware will work properly in all environments and applications, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose.
Do not dispose of WEEE as unsorted municipal waste and have to collect such WEEE separately. Revision PLANET 5/8/16-Port 10/100Mbps SOHO Fast Ethernet Switch User's Manual For Models: FSD-503 / FSD-803 / FSD-1603 Revision: 6.0(Ocotober.2007) Part No: EM_FSD5816v6 (2010-000013-106)
1.2 How to Use This Manual This Fast Ethernet Switch User Manual is structured as follows: Chapter 2 Installation The chapter explains the feature, functionality and the physical installation of the Switch.
Page 7
● Hardware based 10/100Mbps, half / full duplex , flow control and auto-negotia- tion ● IEEE 802.3x flow control for full duplex operation and Backpressure for half du- plex operation ● Integrated address look-up engine, support 1/2/8K absolute MAC addresses ●...
Basic knowledge of networking is assumed. Please read this chapter completely before continuing. In the following section, the term “Switch” means the three Switches, i.e. FSD-503, FSD-803 and FSD-1603; term of “switch” can be any third part switches.
Figure 2-3 FSD-1603 front panel 2.1.3 LED Indicators FSD-503/FSD-803 Color Green Lit: Power on Lit: indicate the link through that port is successfully established. LNK/ACT Green Blink: indicate that the Switch is actively sending or receiving data over that port. Function...
Off: indicate that the port is operating at 10Mbps. 10/100 Green Blink: indicate that the Switch is actively sending or receiving data over that port 2.1.4 Switch Rear Panel Figure 2-4 & 2-5 & 2-6 shows a rear panel of FSD-503 / FSD-803 / FSD-1603.
2.2.1 Desktop Installation To install the Switch on desktop, simply follow the next steps: Step 1: Attach the rubber feet to the recessed areas on the bottom of the Switch. Step 2: Place the Switch on desktop near an AC power source.
Page 13
Step 5: Supply power to the Switch. A. Connect one end of the power cable to the Switch. B. Connect the 12V DC power adapter to a standard wall outlet. When the Switch receives power, the Power LED should remain solid Green.
Ethernet Switch. 3.2 Learning When one packet comes in from any port. The Switch will record the source address, port no. And the other related information in address table. This information will be used to decide either forwarding or filtering for future packets.
10Base-T and 100Base-TX devices can connect with the port in either Half- or Full-Duplex mode. For non auto-negotiation devices, the Switch will only run in Half-duplex mode.
Why the Switch doesn’t connect to the network Solution: Check per port LED on the Switch. Try another port on the Switch Make sure the cable is installed properly Make sure the cable is the right type...
Appendix A Networking Connection A.1 Switch‘s RJ-45 Pin Assignments 10/100Mbps, 10/100Base-TX RJ-45 Connector pin assignment Contact Media Dependant Interface Tx + (transmit) Tx - (transmit) Rx + (receive) 4, 5 Rx - (receive) 7, 8 A.2 RJ-45 cable Pin Assignments The standard RJ-45 receptacle/connector There are 8 wires on a standard UTP/STP cable and each wire is color-coded.
Page 18
Figure A-1: Straight-Through and Crossover Cable Please make sure your connected cables are with same pin assignment and color as above picture before deploying the cables into your network.