Show Command - Planet FNSW-1608PS User Manual

Set Trunk
Set VLAN(n)
Set PoE[n]
Set management VLAN
Set VLAN mode
Set PVID
Set priority
Set IP xxx.xxx.xxx.xxx, mmm.
mmm, mmm, mmm,
ggg.ggg.ggg.ggg
Set Pass
Factory Default
Reboot
Logout
Notice:
Only accept command in lowercase letter under console interface.

4.4.2 Show command

From the main menu screen
appears.
Disable or enable trunk group of FNSW-1608PS.
Configure port-based VLAN group of FNSW-1608PS.
Configure per PoE port of FNSW-1608PS.
Assign management VLAN of FNSW-1608PS.
Disable or enable port-based VLAN function of FNSW-1608PS.
Assign PVID on each port of FNSW-1608PS.
Allow to configure the priority setting of FNSW-1608PS.
Assign IP address, subnet mask, gateway of FNSW-1608PS.
Change the default password of FNSW-1608PS, the maximum length is 4 characters.
Reset the FNSW-1608PS to factory default mode.
Reboot the FNSW-1608PS.
Logout console interface of FNSW-1608PS.
Table 4-1 Detail description of FNSW-1608PS available commands
(see Figure 4-3), input "show" and press enter. The show command list screen in
Figure 4-5 Show command list screen
Figure 4-5
- 16 -