Troubleshooting - Planet FGSW-2402S User Manual

This chapter contains information to help you solve problems. If Giga
Switch is not functioning properly, make sure the Ethernet Switch was
set up according to instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Giga
Switch
Some stations can not talk to other stations located on
The other port
Solution:
The address table may contain older information than of the address
table of that node. Please power down to refresh the address
information
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the
Ethernet Switch is set to full duplex and the partner is set to
half duplex, then the performance will be poor.
FGSW-2402S User's Manual

5. TROUBLESHOOTING

29