Resetting The Audio Functions - Pioneer DVH-P4150UB Operation Manual

Operating this unit
3 Turn MULTI-CONTROL to switch the di-
gital attenuator setting.
! HIGH – High quality sound
! LOW – Minimize distortion sound
# You can also perform the same operations by
pressing a or b.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.

Resetting the audio functions

Only when the multi-channel processor (DEQ-
P7650/DEQ-P6600) is connected to this unit,
you can operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 15)
! Listening position setting (refer to Using
the position selector on page 55)
! Fader/balance setting (refer to Using bal-
ance adjustment on page 55)
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 57)
! Dynamic range control (refer to Using the
dynamic range control on page 57)
! Direct control setting (refer to Using the di-
rect control on page 57)
! Down-mix setting (refer to Using the down-
mix function on page 57)
1 Use MULTI-CONTROL to select RESET in
the initial setting menu.
Refer to Adjusting initial settings on page 43.
2 Press MULTI-CONTROL to display YES/
NO selection.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Turn MULTI-CONTROL to display YES.
4 Press MULTI-CONTROL to display
REALLY?.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
5 Press MULTI-CONTROL to reset audio
functions.
COMPLETE appears in the display.
CRB2932-A/N
<
Section
02
47
En
>47