Dtmf Receiver Check - Panasonic EASA-PHONE KX-T61610 Installation Manual

To set
____..._...-.__._..... until the desired D TMF receiver appears
__
--TX
[38] [NEXT] [SE ECT] [MEMORY] [END]
To confirm
Dial any extension (e.g.. .12) and listen for that extension to ring.
Description Confirmation of DTMF Receiver 1:
DTMF (Dual Tone Multi Frequency) Receiver
-- -.
enables tone telephones to dial within the
system.
To check the DTMF Receivers, activate the
DTMF Receivers one at a time and confirm if
the receiver can receive tone signals.
1. Set the DIALING MODE (located on the
rear of KX-T61630) switch to the TONE
position.
Operation at Extension 11
To Remove DTMF Receiver 2:
1, Set the System Program Switch to the
PROGRAM position.
2. Dial (38) to enter the DTMF mode.
"DTMF RECVER SEL" will be displayed.
3.
Press the NEXT button, twice.
"DTMF 1: ENABLE" and then
"DTMF 2: ENABLE" will be displayed.
4. Press the SELECT button to change to
DISABLE.
"DTMF 2: DISABLE" will be displayed.
5. Press the MEMORY button.
6. Press the END button to return to the initial
program mode.
7. Set the System Program Switch to the SET
positiotl.
6-4
2. Set the POWER FAILURE (located on the
rear of KX-T61630) switch to the ON
position.
3. Dial the extension number (e.g....12).
4.
if
DTMF Receiver is bad, do the following
procedure for removing the DTMF Receiver
after the next step on this section.
5. Set the POWER FAILURE Switch to the
OFF position.
To check DTMF Receiver 2, remove DTMF
Receiver I and confirm that DTMF Receiver 2 is
good by the procedures of "To Remove DTMF
Receiver I" and "Confirmation of DTMF Receiver
&nditions
@"DISABLE" can not be established
on
both
DTMF Receivers-i and 2, at the same time.