Draytek Vigor2920 Series User Manual page 91

Item
After finishing all the settings here, please click OK to activate them.
D e t a i l s P a g e f o r P
D e t a i l s P a g e f o r P
To use PPTP/L2TP as the accessing protocol of the internet, please choose PPTP/L2TP from
Internet Access menu. The following web page will be shown.
Available settings are explained as follows:
Item
PPTP/L2TP Client
Mode
ISP Access Setup
Description
DNS Server IP Address - Type in the primary IP address for
the router if you want to use Static IP mode. If necessary, type
in secondary IP address for necessity in the future.
P T P / L 2 T P i n W A N
P T P / L 2 T P i n W A N
Description
Enable PPTP- Click this radio button to enable a PPTP client
to establish a tunnel to a DSL modem on the WAN interface.
Enable L2TP - Click this radio button to enable a L2TP client
to establish a tunnel to a DSL modem on the WAN interface.
Disable – Click this radio button to close the connection
through PPTP or L2TP.
Server Address - Specify the IP address of the PPTP/L2TP
server if you enable PPTP/L2TP client mode.
Specify Gateway IP Address – Specify the gateway IP
address for DHCP server.
Username -Type in the username provided by ISP in this field.
Password -Type in the password provided by ISP in this field.
Index (1-15) in Schedule Setup - You can type in four sets of
time schedule for your request. All the schedules can be set
previously in Application – Schedule web page and you can
83
1 / W A N 2
1 / W A N 2
Vigor2920 Series User's Guide